OK. After my ride yesterday it was obvious to me that I have some work to do on my front end.

Sooo...

I ordered new Bilstien struts, ball joint, ball joint nut and tie rod ends. This should all be here next week (right after my checkbook explodes).

I need to borrow a ball joint tool.

Anybody gots one????

I will be happy to pay for shipping (mailing) and use.

Thanks in advance... as usual.

I'm guessing your talking about the "socket" for the nut. You can use a pipe wrench or a chisel on it. That might be easier than borrowing a tool.

Matt

That would work for getting it off.

I would *like* to put it back on and torque to proper specs.

Pipe wrench is a stand-by if I can't borrow the correct tool.

send me your address.

As long as you promise to return it, you can borrow it as longas you need.

Thanks Qarl...

I've got you now... you'll never see your tool again... and your little dog too. *Cackle*

I will return it to you in a couple of weeks... you're the best.

PM sent.

if you still need one, headrage is borrowing mine right now, you can use it when he is done

Thanks double A.



Karl has me hooked up.