Wow it works! I can’t believe how close SDS has it programmed! I drove down the road and my Haltec meter is just into the green (rich) led’s, right where it should be.

Don’t get me wrong I still have a lot of major fine-tuning to do, but so far the system rocks!


My accelerator curve isn’t right, it has a low RPM miss, I just replaced a leaking injector etc,etc,etc…

I’m going for a little cruise and I’ll start working some of the bugs out.

Later dudes! Party on!

way to go. Are you planning on dyno tuning it?

Good Job Mark!

I'm sure we're gonna see a lot more posts like this from others in the months to come.

The miss is frustrating I can't get rid of it. I think I need a set of better wires (Magnacor) I also need a better strobe light.

Plus I think I need to read and re-read the manual a bit more.

At driving speeds the set-up isn't that bad, just at idle and off idle. I will keep at it. Let ya know.

M