Michael J
Jul 16 2006, 07:53 PM
I was going to do a quick engine swap. (1.7 to 2.0) Then decided to put in new CV joints , then decided to partially rebuild the tranny and replace the clutch. Now it's all about to go back in and I bolted up the starter and just can not remember where the smaller red wire attaches to.
I think that both the big black wire and the red wire attach to the stud on the solenoid but I just don't remember.
I hope some of you have better memories.
Thanks
ClayPerrine
Jul 16 2006, 09:16 PM
QUOTE(Michael J @ Jul 16 2006, 08:53 PM)
I was going to do a quick engine swap. (1.7 to 2.0) Then decided to put in new CV joints , then decided to partially rebuild the tranny and replace the clutch. Now it's all about to go back in and I bolted up the starter and just can not remember where the smaller red wire attaches to.
I think that both the big black wire and the red wire attach to the stud on the solenoid but I just don't remember.
I hope some of you have better memories.
Thanks
This should help....
Click to view attachment