bam914
Aug 19 2006, 07:14 PM
When boring and honing 914 cylinders shoud you use a torque plate or not?
Mark Henry
Aug 19 2006, 07:28 PM
You must use one.
Twystd1
Aug 19 2006, 07:38 PM
Mandatory....!!!!!!!!!!!!!!!!!!!!!!
Twystd1
Jake Raby
Aug 19 2006, 07:48 PM
Its a must, or you'll end up with a huge taper in the bore...
Blake, I can save you a LOT of trouble and guesswork!
bam914
Aug 19 2006, 08:04 PM
I was 99% sure I had too. Jake I need to get some work done on the block. When is a good time to call you?
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.