Ok guys, I thought I would pick the brains of the 911 6 engine experts. (I posted this also on the 911 Bird board).

I'm trying to figure out what I have here. I bought these a few years back with some Weber's and they are not like the other manifolds that I have. As you can see there is no provision for the cross bar linkage and theye are taller then the stock manifolds. The top (carb) ports are 45.5mm and the bottom (intake) ports are 38mm. The part number on them is 901.108.318.00, I've searched for this part number and haven't found anything.

Anybody seen these or know anything about them?

Thanks
Paul

Click to view attachment

MFI?

Those are so rare
magnesium 906 they had a different linkage. I will accept a comission
http://www.pbase.com/9146gt/other_factory_...g_manifolds_906

I also know some one who will buy em. 906 owner

Actually if you're not going to do anything with them you should send them to Jeff... He maintains a stock of 911 engine stuff that is pretty cool...
They would go to the right place if you did. Not a box in a garage.

Thanks for the link Jeff, that is a cool site on 914GT's and 906's. Yup, these do appear to be 906 parts, I think I'll hang on to them for the time being. They might make a good start to my daughters college fund

Paul

In fact here is a set that uses the standard linkage that sold on ebay recently, 1125.00
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...TRK%3AMEWA%3AIT

lucky b@st@rd

Good for you!!!