to a bent steel bar with a section of threaded rod
When?
Is there a reason other than manufacturing cost?
this is posted here because the CW factor and becuase the likely response is
"dump them and go turbo anyway"
This is for a 74 application
Full Version: Tie rod ends
Early to late the material and construction changed from a cast steel peice
to a bent steel bar with a section of threaded rod
When?
Is there a reason other than manufacturing cost?
this is posted here because the CW factor and becuase the likely response is
"dump them and go turbo anyway"
This is for a 74 application
to a bent steel bar with a section of threaded rod
When?
Is there a reason other than manufacturing cost?
this is posted here because the CW factor and becuase the likely response is
"dump them and go turbo anyway"
This is for a 74 application
I would tend to believe that the bent steel rod is stringer than the cast piece. IDK if this has anything to do with the change though.
QUOTE
stringer
do you me stronger or stingie-er?
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.