Full Version: Bored
Was bored so I decided to recover my alternator wiring harness, cleaned up really well. Cleaned all the contacts, then recovered the harness.
Looks good. Nice Job!
One more showing a little more detail
what's your address so i can send you mine 
nice job
nice job
QUOTE(TROJANMAN @ Dec 1 2006, 01:00 AM) 
what's your address so i can send you mine
nice job
Should be ready for you to pick up at the next RRC.
Very cool! I used the same method (expando tubing and shrink tubing at the ends) for most of my conversion wiring. Really comes out looking good.
-Tony
-Tony
I like it...
In fact, I'm trying to figure a way to recover my FI harness without removing all the connectors...Any thoughts on redoing yours...Ooops, if you have carbs, never mind...
2-OH!
In fact, I'm trying to figure a way to recover my FI harness without removing all the connectors...Any thoughts on redoing yours...Ooops, if you have carbs, never mind...
2-OH!
QUOTE(2-OH! @ Dec 1 2006, 12:14 PM)
I like it...
In fact, I'm trying to figure a way to recover my FI harness without removing all the connectors...Any thoughts on redoing yours...Ooops, if you have carbs, never mind...
2-OH!
I have a D-jet setup and I will be redoing the FI harness basically the same way that I did this one. But the connectors will have to come off.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.