I'm still working on my fuel injection, although I haven't had much time. I need clarification from this website, http://manuals.type4.org/ljet/. I'm checking the double relay, wich is described on the bottom of this page, http://manuals.type4.org/ljet/components/ljet10.htm. I need clarification on this portion, "Also check the voltage at terminals 43/1 and 43/2 against ground to insure that the injection valves are being supplied with full system voltage. See the ectrical Wiring Diagram for terminal identifications." I found the diagram here, http://manuals.type4.org/ljet/introduction/ljet21.htm, and I found terminal 43, but where the heck is terminal 43/1 and 43/2?

Any help is appreciated!

In the diagram terminal 43 is the voltage input to the resistor pack (#12) and they want you to: To check that the injectors are getting voltage you would check at the terminals marked 37,38,40 & 41 at the relay or check at each injector to verify the wiring and connections.