I just installed the Hyfire 6AL with the 29440 coil and the car runs great. The problem is that the rev limiter doesn't seem to be working. To set the unit up correctly I have to move the #2 switch to the up position to indicate a 4 cyl. The little tab only seems to move about 1/16". Is this correct? Should it move further? I don't want to brake the poor little thing.

I know.............I wouldn't have this problem if I'd gone with an 8 conversion!

You have to cut a couple wires as well to set it up. Under a black plastic plug with a screw in the center.

I don't recall if this is related to the rev limiter.

The switches don't move very far. If the car runs, you probably have them set correctly. You should have an extra wheel to set rev limit.

See page 12
http://go.mrgasket.com/pdf/6852M_6853M.pdf