I went to fetch groceries over the weekend in my -6 and when I got home I found the 914-6 logo on the rear panel falling off. It has three pins that protrude through holes in the panel into the rear trunk, but whatever fasteners that are supposed to hold onto those pins have departed. Does anyone know what is supposed to hold the rear logo on? and where I can get them?

Thanks,

----Bill

there are little black buttons,actually rubber encased metal that push on. I believe I have vacuum hose on there now.

vacuum is a wierd word, but fun to type.

I have seen folks thread the bare studs and use nuts and washers, tinnerman nuts are also a possibility(speed nuts) and are available at any good hardware store.

Pelican has them too:

http://www.pelicanparts.com/catalog/shopca..._pg4.htm#item18