I tried searching and seems all the posts I found were about hooking it up...
so I assume it can fit in there.

but as I was looking and about to plop it in, it looks like the tin is in the way
since it is a larger diameter than the current 009. the 009 is right up against it.

so what does everyone else do here? do I just take a BFH and make room?

No expert here, but from reading past post on this subject, I believe most people running the mallory modifiy the tin to make it fit.

Beat the tin in a little bit with a hammer where it interferes with the dizzy body. It's pretty self-explanatory once you get started.

thanks everyone (this board is great!!).

I figured as much... but always like to hear what other people are doing before taking a hammer to things.