solex
Dec 8 2007, 09:49 AM
Can anyone recommend a good machinist on Long Island in Nassau County.
I need to:
(1) resurface my fly wheel
(2) have my cylinders honed
Regarding my cylinders should I bite the bullet and just by a new set and bump the displacement to 2056? What are the implications of doing this on a stock 2.0 liter? My heads were just rebuild by HAM.
Thanks,
Dan
TimT
Dec 8 2007, 10:02 PM
Daltech... not sure if they are still open... Guy was in poor health last year.
S&K could probably surface the flywheel...
Machine shops for Porshce/VW stuff are pretty scare on LI now
We have a place we are training to do 911 heads, but Im not comfortable recommending them yet.
We send alot of our machine work out west....
Closer to home is Verdon Tool and Die in NJ, but sit down and hold your wallet when the bill comes.
solex
Dec 10 2007, 07:02 PM
Thanks, Tim I will check out S&K.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.