QUOTE(1970 Neun vierzehn @ May 11 2008, 12:22 PM)
Will this do........?
Yea, that's what I'm looking for.
You guy's obviously know where I'm going with this.
I'm looking to do a pass through. A scoop on the outside, through the pillar, to the top of the two little pads on the outside of the engine lid.
It would look very close to stock and not interfear with the raising and lowering engine lid.
I have seen add on pieces like this but never an integrated piece
Does the reinforcement piece in the. middle add support incase of a roll over or is it for structural??
I'm looking to do it in metal to avoid the sun ruining the CF.
Black CF would be a neat look to replace the vinyl.