An
ybody know where their locations are?
Full Version: 1975 914 1.8 liter
My idiot mechanic left these laying down.
An ybody know where their locations are?
An
ybody know where their locations are?
Mount them anywhere you like.
Just organize the wires so they're happy.
Just organize the wires so they're happy.
QUOTE(nigolusa @ Jan 30 2009, 01:38 PM) 
My idiot mechanic left these laying down.
An
ybody know where their locations are?both mount on the side of the battery stand. Dr. 914 says that you MUST mount them there.
QUOTE(dr914@autoatlanta.com @ Jan 30 2009, 12:53 PM)
QUOTE(nigolusa @ Jan 30 2009, 01:38 PM)
My idiot mechanic left these laying down.
An
ybody know where their locations are?both mount on the side of the battery stand. Dr. 914 says that you MUST mount them there.
Yeah.. PITA. I have yet to put mine properly back where they belong. Anyone have a picture.
Kyle
QUOTE(nigolusa @ Jan 30 2009, 12:38 PM)
My idiot mechanic left these laying down.
An
ybody know where their locations are?FYI- If your 914 suddenly stops running
check to see if that green band thats holding the relay broke and the relay is loose. It controls the fuel pump. If the green band is actually a locking wire tie, no problem. 
QUOTE(jim_hoyland @ Jan 30 2009, 03:22 PM)
QUOTE(nigolusa @ Jan 30 2009, 12:38 PM)
My idiot mechanic left these laying down.
An
ybody know where their locations are?FYI- If your 914 suddenly stops running
check to see if that green band thats holding the relay broke and the relay is loose. It controls the fuel pump. If the green band is actually a locking wire tie, no problem. Good advice. I found that one out the hard way.
Kyle
Can you please post a picture of the carbon canister mounting position.
Thanks so much!!!!
Thanks so much!!!!
Same photo shows the rough position. A clamp goes around the canister and mounts to the battery hold down bolt.
Can you please post a picture of the carbon canister mounting position.
Thanks so much!!!!
QUOTE(nigolusa @ Jan 31 2009, 06:48 AM)
Can you please post a picture of the carbon canister mounting position.
Thanks so much!!!!
QUOTE(zonedoubt @ Jan 30 2009, 03:58 PM)
I didn't have the original clamp so I bought a large gear clamp (5 to 6 inch diameter) and made a clamp that fits under the battery bolt.
Click to view attachment
Click to view attachment
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.