GA mainshaft gearset......excellent. $350

2 intermediate plates with good bearings
early $200 (tapped hole for -6 throttle linkage)
late $150

F mainshaft gearset....very good $200

'B' first gear set....less reverse, excellent $300

Lots of other gearsets @ $100.....all very good or better.
Also spare cases and R&Ps....cheep.

All of the above have VG dog teeth & syncros.

R & Ps are NOT sold.

All above + shipping.

I don't do Pay Pal.

Hey JP

You got 3rd gear L preferrably or M?

How about T 4th?

Dave

I'm looking for M-S-X. Any or all. Let me know what ya have and I'll send ya a check. I have your address.

Thanks.

None of those, guys. All of the 100 buck sets are stock 914 box sets.

I figured. It was worth a shot... ha ha ha

Got a Billit Intermediate Plate hiding in a box?

T.C.

Nope, can't help.

The R & Ps are solt.

Still have the rest of the stuff. I'll even throw in a slider assy with the gearsets....till they run out.

I wanna move this stuff so I'll entertain decent offers.....even for all......bout 75 lbs worth.

so how much for a stock 1st gear & good dogteeth with its mating gear, a 1st gear slider, both items with sharp teeth, and for two good syncros. i figure a flat rate priorty mail shipping box should contain this stuff. I guess a postal money order is the way you want money? TIA for response

I have good 1st gear sets but no slider....those are tough to come by and THE part in demand. Dr. Evil has a source for new ones.

do you have any tranny rebuilding tools?

Would you have any end covers?...Mine has a busted ear...

The only rebuild tools I have left are those for checking backlash.....home made rig.

I have 2 end covers for side shifters. $25 each + shipping.

how much do you want for it?
nuttin the matter with homemade

The pricy bit is the dial indicator set up. As you can see in the pic, it is mountable bout every where and the arm flexs & locks in place. It also works great for setting cam timing on a 911 engine...which is why I bought it.

The bcklash set up is stuff I fabbed (no rocket science here). The blue tape is no longer there. JB weld (with a release agent) in the 30mm socket took care of the "no wiggle" on the expansion bolt......note, there is no speedo drive in the bolt.

$100 + shipping

PM sent

Bump
Still have trans bits.