 What goes on this connection |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| dt4 |
 Jun 12 2020, 01:34 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 503 Joined: 26-May 19 From: England Member No.: 23,161 Region Association: England 
 |
Underneath the fuel tank
 |
   |
 
|
| mepstein |
Jun 12 2020, 01:42 PM
Post
#2
|
|
914-6 GT in waiting Group: Members Posts: 19,314 Joined: 19-September 09 From: Landenberg, PA/Wilmington, DE Member No.: 10,825 Region Association: MidAtlantic Region
|
Sorry. Read the op wrong.
|
|
|
|
| JOEPROPER |
Jun 12 2020, 01:42 PM
Post
#3
|
|
The answer is "no" unless you ask... Group: Members Posts: 1,184 Joined: 21-November 15 From: White Plains New York Member No.: 19,387 Region Association: North East States
|
QUOTE(dt4 @ Jun 12 2020, 03:34 PM)  Underneath the fuel tank The wire harness connects to the fuel sending unit and the drain tube goes thru the hole under the gas tank. The other 2 are a fuel line and an evap line. |
|
|
|
| RoadGlue |
Jun 12 2020, 01:44 PM
Post
#4
|
|
Sonoma County Gear Head Group: Admin Posts: 2,033 Joined: 8-January 03 From: Santa Rosa, CA Member No.: 108 Region Association: Northern California
|
Do you mean on the second fuel line? There's a lot going on in this photo, so it's hard to know what you're talking about.
The car has both a feed and return line for the fuel system, but if you car was swapped to carbs at some point, then the return line isn't used and may explain why it's disconnected. The wire and connector hanging is the fuel level sender connection, which plugs in on the top of the tank. |
|
|
|
| dt4 |
Jun 12 2020, 02:04 PM
Post
#5
|
|
Senior Member Group: Members Posts: 503 Joined: 26-May 19 From: England Member No.: 23,161 Region Association: England
|
QUOTE(RoadGlue @ Jun 12 2020, 08:44 PM) Do you mean on the second fuel line? There's a lot going on in this photo, so it's hard to know what you're talking about. The car has both a feed and return line for the fuel system, but if you car was swapped to carbs at some point, then the return line isn't used and may explain why it's disconnected. The wire and connector hanging is the fuel level sender connection, which plugs in on the top of the tank. sorry, I realise now that I wasnt very clear you have answered all the questions between you The car is on carbs which explains why there isnt a pipe on the return |
|
|
|
| DickSteinkamp |
Jun 12 2020, 06:36 PM
Post
#6
|
|
Senior Member Group: Members Posts: 500 Joined: 27-February 17 From: Bellingham, WA Member No.: 20,876 Region Association: None |
QUOTE(dt4 @ Jun 12 2020, 01:04 PM) The car is on carbs which explains why there isnt a pipe on the return I think I'd be capping that return line. |
|
|
|
| dt4 |
Jun 13 2020, 01:14 AM
Post
#7
|
|
Senior Member Group: Members Posts: 503 Joined: 26-May 19 From: England Member No.: 23,161 Region Association: England
|
QUOTE(DickSteinkamp @ Jun 13 2020, 01:36 AM) QUOTE(dt4 @ Jun 12 2020, 01:04 PM) The car is on carbs which explains why there isnt a pipe on the return I think I'd be capping that return line. easily done but why is it better to cap? |
|
|
|
| dt4 |
Jun 13 2020, 12:38 PM
Post
#8
|
|
Senior Member Group: Members Posts: 503 Joined: 26-May 19 From: England Member No.: 23,161 Region Association: England
|
so I blocked it off but is wont run now so the tank will need to come back out to remove it to be sure that isnt the cause
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th June 2024 - 02:15 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.