 Another dumb question?, logo in or logo out?? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| East coaster |
 Jul 6 2006, 09:38 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,767 Joined: 28-March 03 From: Millville, NJ Member No.: 487 Region Association: None 
 |
I'm installing my rear window tomorrow and since I already completely cleaned all the tape/residue from the window, there's no longer any tell tale signs of which side was inside and which was out! The only way to distinguish one side from the other is the v-dub logo/text on one side.
Does the little V-dub logo go on the inside or out?? I realize it probably doesn't matter, but I'd rather put it back the way it supposed to be. |
   |
 
|
| Mike McGrath |
Jul 6 2006, 10:01 PM
Post
#2
|
|
Member Group: Members Posts: 98 Joined: 5-December 04 From: Portland, Oregon Member No.: 3,225 |
QUOTE(East coaster @ Jul 6 2006, 08:38 PM)  I'm installing my rear window tomorrow and since I already completely cleaned all the tape/residue from the window, there's no longer any tell tale signs of which side was inside and which was out! The only way to distinguish one side from the other is the v-dub logo/text on one side. Does the little V-dub logo go on the inside or out?? I realize it probably doesn't matter, but I'd rather put it back the way it supposed to be. Someone once told me that it did matter and you were supposed to put it back in the same side in and out. Are you sure you cleaned it that well??? Maybe there's a little left. I'd try it both ways to make sure, just in case. Mike (in Portland) |
|
|
|
| So.Cal.914 |
Jul 6 2006, 10:09 PM
Post
#3
|
|
"...And it has a front trunk too." Group: Members Posts: 6,588 Joined: 15-February 04 From: Low Desert, CA./ Hills of N.J. Member No.: 1,658 Region Association: None |
I haven't done much auto glass, but I have worked as a glazer. When we would
set glass we would put the bug on the inside at the bottem |
|
|
|
| jonwatts |
Jul 6 2006, 11:12 PM
Post
#4
|
|
no rules, just wrong Group: Benefactors Posts: 2,321 Joined: 13-January 03 From: San Jose, CA Member No.: 141  |
If you breath on the glass (fog it up) near the edge you may be able to tell which side had the seal and which didn't.
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st October 2024 - 06:12 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.