 Frankensteen gets NIBBLED |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Joe Bob |
 Apr 18 2004, 08:14 PM
Post
#1
|
|
Retired admin, banned a few times  Group: Members Posts: 17,427 Joined: 24-December 02 From: Boulder CO Member No.: 5 Region Association: None  |
The rust IS bad....so, got me a new "nibbler" and started cutting the floors out. I will be tig welding in tubes from the rear torsion forward to the front to give it more support......16 gauge sheet metal will go into the floors.
Flares WILL be molded in and the 2.2/6 will be installed as soon as that is done. (IMG:http://forums.pelicanparts.com/uploads2/nib1082340629.jpg) Floors.....:eek: (IMG:http://forums.pelicanparts.com/uploads2/nib11082340672.jpg) (IMG:http://forums.pelicanparts.com/uploads2/nib21082340726.jpg) [img] More.... (IMG:http://forums.pelicanparts.com/uploads2/nib3a1082340971.jpg) (IMG:http://forums.pelicanparts.com/uploads2/nib4a1082340989.jpg) |
   |
 
|
  |
Replies(1 - 2)
| Joe Bob |
Apr 18 2004, 08:16 PM
Post
#2
|
|
Retired admin, banned a few times Group: Members Posts: 17,427 Joined: 24-December 02 From: Boulder CO Member No.: 5 Region Association: None |
UPDATE on "Manfred"....oil tank is in, plumbing is 75% done.....will be finishing oil lines tomorrow or the next day and then do some trial fitting of the engine and trans.....
|
|
|
|
| rick 918-S |
Apr 18 2004, 11:09 PM
Post
#3
|
|
Hey nice rack! -Celette Group: Members Posts: 20,473 Joined: 30-December 02 From: Now in Superior WI Member No.: 43 Region Association: Northstar Region 
|
Lot of work going on at your place!
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 01:32 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.