Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Six SC Distributor, Distributor Question
marinmcgreevy
post Nov 5 2004, 09:29 PM
Post #1


Member
**

Group: Members
Posts: 55
Joined: 24-June 04
From: Mill Valey, CA
Member No.: 2,243



I have a question regarding the distributor on my 914/6. I have been told by the PO that the distributor on my engine (1981 SC w/98mm JE pistons) is a Bosch unit that rotates in the same direction as the original 2.0 and not in the reverse direction of a normal SC distributor. He said it has a special curve and required a different gear to work on the SC block. There are no points or no vacuum diaphragm on the distributor. It has a Permatune CDI. I have not been able to read any markings on the distributor. The engine was built ten years ago and the previous owner has not been able to find the file with all the engine specs. Does the discription of the distributor ring a bell to anyone?

The car runs great and I have not checked the timing yet. However, someday I will and I am looking for any information.

Any information would be greatly appreciated.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies(1 - 2)
SLITS
post Nov 6 2004, 01:31 AM
Post #2


"This Utah shit is HARSH!"
**********

Group: Benefactors
Posts: 13,602
Joined: 22-February 04
From: SoCal Mountains ...
Member No.: 1,696
Region Association: None



Ok, he took a normal Bosch 6 cyl dizzy, had the drive gear changed and recurved the dizzy. Plausible, but expensive for a single gear. I'm not a six person and did not know the rotation of the dizzy was different in an SC.

If they completely rebuilt it, the could have media blasted the numbers off it or if it was an early one with the metal tag, they just removed it.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
michel richard
post Nov 6 2004, 04:36 PM
Post #3


Senior Member
***

Group: Members
Posts: 1,291
Joined: 22-July 03
From: Longueuil, Québec
Member No.: 936



I've actually done something similar. But if the gear on the distributor shaft has been changed, the drive gear on the crankshaft must have been changed too, which means it can only have been done at a point in time where the whole engine was apart.
The distributor shafts are the same diameter and the gear from one will physically fit onto the other.
As for recurving, you need to swap the whole advance plate, because the advance would otherwise become a retard. Once again, it can be done.
I have found that a lot of parts inside the various Bosch distributors share common dimensions, whether they were on a VW, a Porsche, a SAAB or whatever. I've built a couple of distributors using later VW Golf parts inside an otherwise stock 914-4 distributor.

Michel Richard
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 17th June 2024 - 09:46 AM