 I know this sounds dumb, where is the cht on a 1970 1.7? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| buck toenges |
 May 16 2014, 09:07 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 553 Joined: 25-November 03 From: Fort wayne In Member No.: 1,388 Region Association: None 
 |
I assume it is on the passenger side cylinder head toward the back of the car but where is it? Do I have to take off the tin to get to it?
Thanks, Buck By the way it was way easier to hook up a 3.2 f.i. system then putting a d-jet back on a 1.7. |
   |
 
|
  |
Replies(1 - 3)
| bdstone914 |
May 16 2014, 09:52 PM
Post
#2
|
|
bdstone914 Group: Members Posts: 4,906 Joined: 8-November 03 From: Riverside CA Member No.: 1,319 |
QUOTE(buck toenges @ May 16 2014, 08:07 PM)  I assume it is on the passenger side cylinder head toward the back of the car but where is it? Do I have to take off the tin to get to it? Thanks, Buck By the way it was way easier to hook up a 3.2 f.i. system then putting a d-jet back on a 1.7. It is on the passenger side. It can be removed without removing the tin if you can improvise a tool. Some people have cut a slit in a deep well socket to clear the wire. You can notch the end of the socket that takes the ratchet. |
|
|
|
| mepstein |
May 17 2014, 05:48 AM
Post
#3
|
|
914-6 GT in waiting Group: Members Posts: 19,876 Joined: 19-September 09 From: Landenberg, PA/Wilmington, DE Member No.: 10,825 Region Association: MidAtlantic Region
|
Located on passenger side towards the back of the engine. There's a hole in the tin to reach it. Takes 2 minutes to remove or install. Buy a $5 deep well socket. Stuff the wire into the socket to remove and reinstall. No cutting, grinding or tin removal needed.
|
|
|
|
| Dave_Darling |
May 17 2014, 10:17 AM
Post
#4
|
|
914 Idiot Group: Members Posts: 15,161 Joined: 9-January 03 From: Silicon Valley / Kailua-Kona Member No.: 121 Region Association: Northern California
|
Look around for holes in the engine tin near the #3 spark plug. There should be one hole with a single wire coming up out of it; that's the Temp Sensor II wire and the sensor is at the end of it.
--DD |
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 04:46 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.