 Pedrinnis, Tight Fit |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Allan |
 Dec 10 2005, 05:15 PM
Post
#1
|
|
Teenerless Weenie  Group: Members Posts: 8,373 Joined: 5-July 04 From: Western Mesopotamia Member No.: 2,304 Region Association: Southern California  |
I finally got my adapters off and have started to put on a set of Pedrinnis. The rears went on fine but the fronts seem to be a really tight fit where the boss on the hub fits into the rim. Is it normally a press fit? I know that there is a certain part number for the later cars and according to Slits these are the correct ones.
|
   |
 
|
  |
Replies(1 - 3)
| Allan |
Dec 10 2005, 06:49 PM
Post
#2
|
|
Teenerless Weenie Group: Members Posts: 8,373 Joined: 5-July 04 From: Western Mesopotamia Member No.: 2,304 Region Association: Southern California |
Nobody running Pedrinnis? (IMG:http://www.914world.com/bbs2/html/emoticons/confused24.gif)
|
|
|
|
| Dave_Darling |
Dec 10 2005, 07:16 PM
Post
#3
|
|
914 Idiot Group: Members Posts: 14,991 Joined: 9-January 03 From: Silicon Valley / Kailua-Kona Member No.: 121 Region Association: Northern California 
|
Look at the part number on the back. If it ends in ".00", and you have a 73+ car, you will not be able to fit the Pedrinis on the front hubs. If the part number ends in ".01", or you have a 70-72 car, then you may just have some rust on the hub, perhaps...
--DD |
|
|
|
| Allan |
Dec 10 2005, 07:21 PM
Post
#4
|
|
Teenerless Weenie Group: Members Posts: 8,373 Joined: 5-July 04 From: Western Mesopotamia Member No.: 2,304 Region Association: Southern California |
Thanks Dave. I got them on. It's a pretty tight fit, especially if you don't run them regularly. You were right on the rust issue. If you change over to them you need to clean things up a little bit. These were tight but fit well.
Thanks... |
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 04:26 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.