Tangerine Racing Header, First post install impressions... |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Tangerine Racing Header, First post install impressions... |
ConeDodger |
Sep 3 2006, 09:26 PM
Post
#1
|
Apex killer! Group: Members Posts: 23,609 Joined: 31-December 04 From: Tahoe Area Member No.: 3,380 Region Association: Northern California |
Well, today my 4 cylinder came off the jackstands after getting a set of Tangerine Racing Headers installed by none other than Mr. North Bay 914, Martin Baker.
Thanks Martin... Seems I say that a lot... Anyway, my first impression is that the car revs easier, pulls harder, idles better, and all around runs great with them. A feature I didn't expect is that they are relatively quiet... Louder yes, but gone is that VW sound. Very nice. A couple of cautions for people planning this project: First of all, plan to protect your starter and its wiring. We melted down the battery positive cable about 4 inches from the starter. Probably not a design flaw on Chris Foley's part. My car has a Hi Torque aftermarket starter and the position of the wires is different than the stock starter. Second, watch your driver side e-brake cable. You can toast this as well. It is possible to wire tie it up away from the header. Third, watch your speedometer cable and clutch cable. I covered mine with a heat shield wrap over the foot or so that they travel an inch or so from the header. I expect Mr. Baker will chime in with his comments as he turned the wrenches for this job. I sat in the bench racing chairs just outside the garage and chased tools. My hats off to Chris Foley for a truely quality 914 product. (IMG:style_emoticons/default/beerchug.gif) And as always, my hats off to Martin Baker for his expertise. A true friend. Honorable Mention goes to Alison Baker for lending me Martin for a few hours... |
McMark |
Sep 4 2006, 02:29 PM
Post
#2
|
914 Freak! Group: Retired Admin Posts: 20,179 Joined: 13-March 03 From: Grand Rapids, MI Member No.: 419 Region Association: None |
Sounds like a fun project. (IMG:style_emoticons/default/biggrin.gif)
I can't wait to hear it in person. (IMG:style_emoticons/default/driving.gif) |
JPB |
Sep 4 2006, 02:33 PM
Post
#3
|
The Crimson Rocket smiles in your general direction. Group: Members Posts: 2,927 Joined: 12-November 05 From: Tapmahamock, Va. Member No.: 5,107 |
(IMG:style_emoticons/default/thisthreadisworthlesswithoutpics.gif)
(IMG:style_emoticons/default/beer.gif) Pic prick!!!! Or, don't tease at all you nonpleaser! |
ConeDodger |
Sep 4 2006, 02:34 PM
Post
#4
|
Apex killer! Group: Members Posts: 23,609 Joined: 31-December 04 From: Tahoe Area Member No.: 3,380 Region Association: Northern California |
Sounds like a fun project. (IMG:style_emoticons/default/biggrin.gif) I can't wait to hear it in person. (IMG:style_emoticons/default/driving.gif) You will brother... I will be down soon. In some ways it sounds like the six but not quite as evil. Hey are you going down to GAF? I am looking for a co-driver and someone to share expenses for the room? Martin may not go. |
McMark |
Sep 4 2006, 02:37 PM
Post
#5
|
914 Freak! Group: Retired Admin Posts: 20,179 Joined: 13-March 03 From: Grand Rapids, MI Member No.: 419 Region Association: None |
I'm on the fence, Rob. I'll let you know ASAP if I can make it. (IMG:style_emoticons/default/wink.gif)
|
North Bay 914 |
Sep 5 2006, 09:42 PM
Post
#6
|
Senior Member Group: Members Posts: 509 Joined: 25-January 05 Member No.: 3,504 |
This exhaust is a quality part, without doubt. The street version, which I installed on Rob's car has great sound, and not to loud. Makes the 4 cylinder engine sound very good. The fit is good, and not hard to install. Welds are beautiful, A+
We still have to install the heat exchanger, but in Sacramento, winter won't be here for couple of months...we have a little time. Attached image(s) |
Lo-Fi Version | Time is now: 4th June 2024 - 09:43 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |