 HE problem/opinion |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| markwemple |
 Apr 11 2008, 06:07 PM
Post
#1
|
|
Member  Group: Members Posts: 68 Joined: 27-November 07 From: Severna Park, MD Member No.: 8,380 Region Association: MidAtlantic Region  |
The guy who replaced my HEs used the old gaskets. Now, one side, I can't remove the old gaskets and on the other, one bent and pulled a stud. I hate this Fing design and am about to just go back to 911s exclusively. A completly BS design!!!!!!!
Can I use the old gaskets w/o having a major leak? I am seriously pissed at this thing. Been working on theis for about 6 hours now. About as long as it takes to do a quick rebuild on a type 1. |
   |
 
|
  |
Replies
| BMartin914 |
Apr 12 2008, 09:40 AM
Post
#2
|
|
||| Group: Members Posts: 1,408 Joined: 30-May 04 From: Oregon Member No.: 2,128 Region Association: Pacific Northwest |
25 ft lbs could potentially pull the threads out of the head...
18 ft/lbs is the correct spec. DO NOT use weatherstrip adhesive to hold the copper gaskets to the head, or any other "adhesive" for that matter, and stop listening to the person that told you to do that... Slightly enlarge the gaskets with a pair of expanding pliers. Open them up a little in the middle and they will hold in the head. |
|
|
|
Posts in this topic
markwemple HE problem/opinion Apr 11 2008, 06:07 PM
dw914er these cars can have their tough moments, and yes, ... Apr 11 2008, 06:16 PM Brando So on your 911, when you try to switch to stainles... Apr 11 2008, 06:17 PM
markwemple
So on your 911, when you try to switch to stainle... Apr 11 2008, 06:23 PM r_towle You can pull the gasket, its a copper gasket, just... Apr 11 2008, 06:36 PM markwemple OK. some more questions. What is the torque spec o... Apr 11 2008, 09:04 PM r_towle Lets start with NO..
Dont use 3m anything...for th... Apr 11 2008, 09:27 PM type47 i have a reply by Raby to a post that exhaust nut ... Apr 12 2008, 06:53 AM charliew On subies we use a red high temp silicon that neve... Apr 12 2008, 09:35 AM rhodyguy use a 1/4" drive socket on the he nuts. the t... Apr 12 2008, 10:14 AM markwemple Update:
I used a combo of ideas posted and given.... Apr 12 2008, 12:03 PM r_towle Ask Jake for the stepped studs.
Rich Apr 12 2008, 02:03 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 08:40 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.