 High Idle w/ rebuilt carbs, looking for some help |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| JBart |
 May 4 2008, 11:00 PM
Post
#1
|
|
UNDER CONSTRUTION  Group: Members Posts: 110 Joined: 9-October 06 From: Wildomar Ca. Member No.: 7,019  |
I just had a set of 40's rebuilt for my 72'1.7 . A buddy of mine that knows webers like the back of his hand rebuilt them and we put them on today but the car won't idle down below 1800< > when he adjusted the mixture screw the car wouldn't even die . I don't have the smarts for carbs so bear with me . Thanks for your input ahead of time
Thanks, jbart |
   |
 
|
  |
Replies
| ConeDodger |
May 5 2008, 01:10 AM
Post
#2
|
|
Apex killer! Group: Members Posts: 23,622 Joined: 31-December 04 From: Tahoe Area Member No.: 3,380 Region Association: Northern California 
|
The manifolds can leak too...
|
|
|
|
| KaptKaos |
May 5 2008, 10:46 AM
Post
#3
|
|
Family Group: Members Posts: 4,009 Joined: 23-April 03 From: Near Wausau Member No.: 607 Region Association: Upper MidWest |
QUOTE(ConeDodger @ May 4 2008, 11:10 PM)  The manifolds can leak too... DOH! You'd think I would have mentioned that as that was a huge issue for me that I just recently fixed!! Also, make sure that your air bypass valves are all the way in. That lets extra air in as well. |
|
|
|
Posts in this topic
JBart High Idle w/ rebuilt carbs May 4 2008, 11:00 PM
KaptKaos Make sure your linkage isn't binding and preve... May 5 2008, 12:01 AM JBart We checked for leaks there doesn't seem to be ... May 5 2008, 07:10 AM rhodyguy with the cable disconnected and the pass side idle... May 5 2008, 08:26 AM JBart Going out to work on her right now and as far as t... May 5 2008, 06:25 PM
KaptKaos
as far as the air reads the lft. frnt reads 7 and... May 5 2008, 07:03 PM r_towle Check left front and rear....should be the same.
C... May 5 2008, 06:44 PM JBart A BIG Thanks to everybody who chimed in!!... May 5 2008, 10:57 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 08:55 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.