 Question about Master Cylinder |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| WizPorsche914 |
 May 15 2008, 08:52 PM
Post
#1
|
|
Member  Group: Members Posts: 132 Joined: 17-December 07 From: Douglassville PA Member No.: 8,479 Region Association: MidAtlantic Region  |
I have a question. Im going to replace my Master Cylinder soon. What tools will I need to do the job and is it easy.
|
   |
 
|
  |
Replies
| TravisNeff |
May 15 2008, 08:58 PM
Post
#2
|
|
914 Guru Group: Members Posts: 5,082 Joined: 20-March 03 From: Mesa, AZ Member No.: 447 Region Association: Southwest Region 
|
13mm wrench: for the MC to the body of the car
needle nose pliers, to pull the electrical connector(s) and pull/install the feed tubes It's a fairly straightforward job, but it is a real bitch to get the feed lines seated into the new MC. |
|
|
|
Posts in this topic
WizPorsche914 Question about Master Cylinder May 15 2008, 08:52 PM
!Wet Spot! First you buy one of the Clymer or Haynes books. ... May 15 2008, 08:56 PM
ejm
It's a fairly straightforward job, but it is ... May 15 2008, 09:24 PM !Wet Spot! Oh yeah, don't forget the reset button on the ... May 15 2008, 08:59 PM So.Cal.914 !Wet Spot! May 15 2008, 07:59 PM Post #4 ... May 15 2008, 09:06 PM ericread
!Wet Spot! May 15 2008, 07:59 PM Post #4... May 16 2008, 01:38 PM !Wet Spot! It's what my Dad used to call me when he was p... May 15 2008, 09:09 PM 9146986 Sometimes a flare wrench works much better than an... May 16 2008, 11:56 AM Cap'n Krusty
Sometimes a flare wrench works much better than a... May 16 2008, 02:30 PM trapper QUOTE(Travis Neff @ May 15 2008, 10:58 PM) *
It... May 18 2008, 07:01 PM trapper QUOTE(Travis Neff @ May 15 2008, 10:58 PM) *
It... May 19 2008, 06:59 PM rfuerst911sc
QUOTE(Travis Neff @ May 15 2008, 10:58 PM) *
It... May 19 2008, 07:10 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st July 2025 - 06:54 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.