 Strut to a-arm to ball joint pin not fitting, did I get the wrong pin or will a bigger hammer work? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| neo914-6 |
  Jul 21 2008, 09:14 PM
Post
#1
|
|
neo life  Group: Members Posts: 5,086 Joined: 16-January 03 From: Willow Glen (San Jose) Member No.: 159  |
the strut hole and notch in the a-arm ball joint shaft:
 the chamfered pin:  |
   |
 
|
  |
Replies
| neo914-6 |
Jul 22 2008, 03:38 AM
Post
#2
|
|
neo life Group: Members Posts: 5,086 Joined: 16-January 03 From: Willow Glen (San Jose) Member No.: 159 |
Strut has a hole, the ball joint notch is more V shaped. Here's an older pic of a ball joint with a semi-circle notch vs V notch.
 It's 911 Boge with 914 a-arm. Pelican #'s same #'s, pic does not show the notch 911-341-049-01-M69 Ball Joint, 911/911 Turbo (1974-89) 911-341-049-01-M69 Ball Joint, 2 Per Car, 911 (1972-89)  same #'s 901-341-049-00-M69 Ball Joint, 911 (1972-89) has semi-circle notch 901-341-049-00-M69 Ball Joint, 914 1.7 (1970-06/72), 914-6 (1970-06/72) NOTE: use 900-075-111-08-OEM Bolt, Hex-Head M10 x 30, 911 (1965-73)  only 1 # for these, same as mine pictured above 911-341-119-06-M260 Threaded Pin for Ball Joint Attachment, 911 (1972-73) 911-341-119-06-M260 Threaded Pin for Ball Joint Attachment, 911 (1974-89) Elephant sells these decambered BJ's for $350. fits 72-89 and has the V notch...  This tells me the V notch is correct with the pin I have, now to figure why it's not aligning... |
|
|
|
Posts in this topic
neo914-6 Strut to a-arm to ball joint pin not fitting Jul 21 2008, 09:14 PM
Dr Evil Does the post of your ball joint have a notch in i... Jul 21 2008, 09:16 PM michelko Hi if there is a sloton the bottom of the strut, y... Jul 22 2008, 01:55 AM chris914 To get mine to align I used a jack to lift the arm... Jul 22 2008, 04:20 AM
neo914-6
To get mine to align I used a jack to lift the ar... Jul 22 2008, 05:08 AM 914Sixer Use a round punch to align hole. It seems like th... Jul 22 2008, 07:37 AM neo914-6
Use a round punch to align hole. It seems like t... Jul 27 2008, 11:16 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th October 2025 - 09:54 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.