 JB Weld on Por 15, Stick?? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| AvalonFal |
  Sep 12 2008, 12:57 PM
Post
#1
|
|
Member  Group: Members Posts: 483 Joined: 3-July 05 From: Southern New Jersey Coast Member No.: 4,367 Region Association: MidAtlantic Region  |
Getting ready to JB Weld a few nuts on a Por 15 treated surface and I'm wondering how well the JB will stick to the Por 15. Anybody have any experience or thoughts??
Paul |
   |
 
|
  |
Replies
| Mark Henry |
Sep 12 2008, 01:48 PM
Post
#2
|
|
that's what I do! Group: Members Posts: 20,065 Joined: 27-December 02 From: Port Hope, Ontario Member No.: 26 Region Association: Canada |
QUOTE(AvalonFal @ Sep 12 2008, 02:57 PM)  Getting ready to JB Weld a few nuts on a Por 15 treated surface and I'm wondering how well the JB will stick to the Por 15. Anybody have any experience or thoughts?? Paul Yes I have a few thoughts and #1 is why would you do this? |
|
|
|
| AvalonFal |
Sep 12 2008, 02:18 PM
Post
#3
|
|
Member Group: Members Posts: 483 Joined: 3-July 05 From: Southern New Jersey Coast Member No.: 4,367 Region Association: MidAtlantic Region |
QUOTE(Mark Henry @ Sep 12 2008, 03:48 PM) Yes I have a few thoughts and #1 is why would you do this? It's to reset a broken captured nut under the dash frame that a wrench can't get to without moving a lot of wiring and switches, but I can get my fingers to. Thought I'd just set it into some JB to keep it from spinning when tightening/loosening. Now, does anybody have any experiences with JB holding on Por?? Paul |
|
|
|
Posts in this topic
AvalonFal JB Weld on Por 15 Sep 12 2008, 12:57 PM
scrz914 No, you're probably the first.
However, I... Sep 12 2008, 02:37 PM Eric_Shea Good idea Paul.
JB Weld is awesome. No experienc... Sep 12 2008, 02:38 PM
kwales When building aircraft structures, the sequence is... Sep 13 2008, 01:31 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 29th May 2024 - 04:38 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.