 Welding gas cylinder, what size? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ipozestu |
 Nov 6 2008, 10:24 AM
Post
#1
|
|
Newbie  Group: Members Posts: 6 Joined: 30-October 07 From: Norcal Member No.: 8,281  |
I'm about to put a '75 in the air that's been sitting in my garage for a year. This will be my first crack at rust repair. The Hell hole and lower long area is where the most attention is needed.
I'm new to welding, I've picked up so much information here I feel pretty good about starting this. I picked up a Lincoln 3200HD off craigslist for $200. I've got a regulator, now I need a cylinder. What size should I get? I was looking at a 20lb bottle available on craigslist. It was designated as CO2. Is that the right bottle? Can it be filled with mix gas? Should I get something bigger? Tips. tricks, comments, suggestions? Thanks |
   |
 
|
  |
Replies
| cobra94563 |
Nov 6 2008, 10:36 AM
Post
#2
|
|
Chris Group: Members Posts: 341 Joined: 1-March 05 From: San Francisco Member No.: 3,696 |
I have a similar welder and I got the 40CF. It last pretty long, but I had to refill a couple times already.
Places will exchange tanks on fills unless you wait for "your" tank be filled. I got mine off ebay - if you can't find one on craigslist. I was good quality, but it didn't matter once exchanged. |
|
|
|
Posts in this topic
ipozestu Welding gas cylinder, what size? Nov 6 2008, 10:24 AM
dakotaewing Buy the biggest bottle you can afford -
The cost d... Nov 6 2008, 10:39 AM
Wes V I believe that the bottle has to be bought from th... Nov 6 2008, 11:21 AM Millerwelds If you are going to use CO2 then a smaller bottle ... Nov 6 2008, 11:42 AM Todd Enlund
You can not use a CO2 cylinder for mixed gas as i... Nov 6 2008, 02:44 PM Todd Enlund Different categories of gas have different threads... Nov 6 2008, 11:47 AM jmill I bought the 70 cf one. The small ones have a hab... Nov 6 2008, 01:40 PM Spoke Bought the 80 cubic foot tank from a place in Jers... Nov 6 2008, 03:55 PM cobra94563 True - 80cf will last 2xs a 40cf...but,
that linco... Nov 6 2008, 05:06 PM Millerwelds My bad - same valve on mixed gas and co2. It is t... Nov 6 2008, 05:22 PM Todd Enlund I have a 234cf Nitrogen cylinder that I hope to us... Nov 6 2008, 05:36 PM kwales I bought the small one and it lasted for an hour o... Nov 7 2008, 06:36 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th July 2025 - 10:23 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.