Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> One parking brake won't release
PinetreePorsche
post Nov 17 2008, 09:53 AM
Post #1


Member
**

Group: Members
Posts: 235
Joined: 14-November 05
From: Falls Church, VA
Member No.: 5,124



My '73, in pretty good shape, although the pass. side parking brake was weak-- badly out of adjustment. Brake held pretty well with mostly the drivers side. All pads in fair shape. I parked it on the more steeply sloped part of the driveway last week, didn't use it for a week (not unusual-- sometimes it well sit 2-3 weeks), and when I started it and put it in gear, and released the handle, it wouldn't move. If its in first, it tucks down at that wheel-- ie compresses the suspension; if in reverse, it rises up on the suspension. I don't think its a rust-frozen cable-- never any cable hang-up before, and I lubed it as best I could last time I was into that wheel. I did pull up the brake handle extra hard when I parked it, maybe got one more click on it than usual, when I parked it. Haven't jacked it and tried to get the wheel off, partly because it's on the slope, and would need to be cabled or chained to my van parked in front to assure it doesn't slide/roll/slip downhill and fall off the jacks, although I'm willing to do that when I think I know what I'm going in for. I wonder if something inside the wheel could have gone "too far" and jammed? I assume the tuck or rise means something to someone very familiar with the weird rear calipers on the 914. Any ideas?
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
wbergtho
post Nov 17 2008, 10:47 AM
Post #2


Senior Member
***

Group: Members
Posts: 1,314
Joined: 28-April 03
From: Roberts, WI
Member No.: 623



Be sure that the cable and or emergency brake handle and corresponding short cable, spring and all parts are free and lubricated properly. Disconnect the cable at the caliper and see if you can manually actuate the caliper with the lever. If not, you have a problem with the caliper and or rotor. If the venting isn't set properly, if the rotor is worn way down and if the caliper needs freshening...your problem could exist there. If the condition of the cable is suspect and/or cable isn't adjusted properly at the firewall on both cables...you may run into problems...and as said before if the handle and cooresponding parts are frozen due to rust...make sure they are lubricated. Could be any number of the above problems.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 16th June 2024 - 11:10 AM