 CV Joint grease, what are you using? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| dlestep |
 Dec 20 2008, 10:51 PM
Post
#1
|
|
I am smilin'...  Group: Members Posts: 890 Joined: 15-January 08 From: Sunrise Florida Member No.: 8,573 Region Association: South East States  |
...I've been looking at different stuff, like
Moly 60, Optimoly, Lubriplate, Kendall... What's new? What's good? What are you using? |
   |
 
|
  |
Replies
| Eric_Shea |
Dec 27 2008, 07:34 PM
Post
#2
|
|
PMB Performance Group: Admin Posts: 19,304 Joined: 3-September 03 From: Salt Lake City, UT Member No.: 1,110 Region Association: Rocky Mountains  |
QUOTE CV's have a hard life in 914's, especially the inboads. Aft of the engine, directly above the exhaust. Cheap grease will turn to clay from the heat. Grease is not expensive but the job is pretty unpleasant so you don't want to be doing it any more often than you need to. Couple that with hard-to-replace CV's and the result is: use good grease... Could have said it better myself... so I didn't. Thanks Rich! (IMG:style_emoticons/default/biggrin.gif) http://www.pmbperformance.com/catalog/item...868/6620271.htm |
|
|
|
Posts in this topic
dlestep CV Joint grease Dec 20 2008, 10:51 PM
johnnie5 Good question. I am going to rebuild/regrease/rebo... Dec 24 2008, 06:10 PM familienauto Last time I did a CV was on my Ghia. I just used t... Dec 25 2008, 02:02 PM sww914 Swepco Dec 25 2008, 04:25 PM Rusty Considering that my axles will likely be apart in ... Dec 25 2008, 04:56 PM ArtechnikA Swepco 101 or LubroMoly CV Grease.
(IMO - 5 years... Dec 27 2008, 03:36 PM Krieger914 SWEPCO Dec 27 2008, 04:01 PM dlestep ...after looking into this I found that the low pr... Dec 27 2008, 04:09 PM Mark Henry swepco or if I get the Lobro boot kits the grease ... Dec 27 2008, 04:30 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 12:52 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.