 Flywheel replace?, when do you need too? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| eg914 |
 Jan 12 2009, 01:30 AM
Post
#1
|
|
Member  Group: Members Posts: 319 Joined: 17-June 04 From: Elk Grove, CA Member No.: 2,223 Region Association: None  |
Pulled the trans for an oil seal replacement, and my clutch disc is down to the rivets on the pressure plate side. I thew in an old disc to keep me going (daily driver).
My question is, can I reuse the flywheel I have, or does it need to be resurfaced or replaced? How can I tell if the flywheel is OK to use as it is? Seems like the Pelican and AA kits can include flywheels, but that adds a bit to the cost. Just trying to figure out what the hit to the budget is going to be. Thanks |
   |
 
|
  |
Replies
| So.Cal.914 |
Jan 13 2009, 01:27 AM
Post
#2
|
|
"...And it has a front trunk too." Group: Members Posts: 6,588 Joined: 15-February 04 From: Low Desert, CA./ Hills of N.J. Member No.: 1,658 Region Association: None |
I would check it for sure.
|
|
|
|
Posts in this topic
eg914 Flywheel replace? Jan 12 2009, 01:30 AM
southernmost914 You should at least resurface it to keep it from g... Jan 12 2009, 08:06 AM So.Cal.914 Just make sure the face has not been cut so much t... Jan 12 2009, 08:50 AM eg914 Thanks for the replies. Guess I will have to spen... Jan 12 2009, 10:45 PM Mark Henry You must check the end play if you change flywheel... Jan 13 2009, 06:48 AM
Jake Raby
You must check the end play if you change flywhee... Jan 13 2009, 07:26 AM Porsche Rescue Jake, can you tell from this pic if the flywheel c... Jul 8 2009, 05:39 PM Jake Raby It looks low, but **may** have one more life in it... Jul 8 2009, 08:14 PM Porsche Rescue Can you tell me the spec? Search here is unclear. ... Jul 8 2009, 10:58 PM John Jentz You will probably be ok as long as there is still ... Jul 9 2009, 09:31 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th June 2024 - 01:22 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.