Peter from TX... 1970 914/6 Restoration & build th, My introduction & build thread -- PICS I Options

[AgPete139]

Howdy everyone! (IMG:style_emoticons/default/biggrin.gif)

My name is Peter and I am new to the world of Porsche. A number of months ago, I was given permission to restore my fathers 1970 914/6 in all original condition, and have recently (last week) begun the restoration process. I am so excited to get my father's first car back in running condition. It has sat in the garage for the last 28 years, and age has taken its toll. Rust (battery and trunk lid seals, etc.), some dry rot, numerous dents and bangs, and seizure to name a few. (IMG:style_emoticons/default/headbang.gif)

Now, on with the pics!

(IMG:http://www.914world.com/bbs2/uploads_offsite/img.photobucket.com-8701-1392368562.1.jpg)

(IMG:http://www.914world.com/bbs2/uploads_offsite/img.photobucket.com-8701-1392368562.2.jpg)

(IMG:http://www.914world.com/bbs2/uploads_offsite/img.photobucket.com-8701-1392368562.3.jpg)

(IMG:http://www.914world.com/bbs2/uploads_offsite/img.photobucket.com-8701-1392368563.4.jpg)

(IMG:http://www.914world.com/bbs2/uploads_offsite/img.photobucket.com-8701-1392368563.5.jpg)

(IMG:http://www.914world.com/bbs2/uploads_offsite/img.photobucket.com-8701-1392368563.6.jpg)



I am starting on the front end (steering, suspension, brakes) and I have come to a wall. Is there anyone in the Houston area (or willing to lend...I am honest) that will let me borrow a pin tool (4 grooved/pronged) for the lower strut?


Are there any other special tools that I will actually need when I rebuild the engine etc.? For instance, the front hub "required" a special tool resembling a mini crowbar, but a medium flathead and prying did the job just fine. Is this grooved socket worth the $65 to buy, and what are your thoughts on replacing it with a regular hex nut of the same thread and suspension washer for ease of removal for the future?

I have also done quite a bit of researching, and have acquired the original shop manuals for this unique beauty.

Any questions or pointers, I'd love to hear them! (IMG:style_emoticons/default/popcorn[1].gif)



Pete

[charliew]

Pete try to measure all six pistons to see how much they vary in od. I think you can find one used piston exactly like the broke one and the same od size. I would only have the cylinders honed and clean the pistons up and get another one and use them with new rings. The cylinders are not scoured or worn. I don't see a wear pattern where the rings stop at the top of the cylinder so there is not much wear. The piston might have fallen down and hit the case when you pulled the cylinder off.