 New Euro Race headers dont fit? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| biosurfer1 |
 Apr 23 2009, 09:34 PM
Post
#1
|
|
Teener fo Life!  Group: Members Posts: 3,020 Joined: 3-August 03 From: Roseville, CA Member No.: 977 Region Association: Northern California  |
I am in the process of putting on my Euro Racing headers and they are not lining up now...any idea what I'm doing wrong?
The stub pipes are on fine and the passenger side headers went on fine too, but when I got to the drivers side, they are off by quite a bit. Here is the passenger's side:  and here is how the driver's sides line up:   Did I do something wrong?? |
   |
 
|
  |
Replies
| jasons |
Apr 23 2009, 10:20 PM
Post
#2
|
|
Jackstand Extraordinaire Group: Members Posts: 2,011 Joined: 19-August 04 From: Scottsdale, AZ Member No.: 2,573 Region Association: None |
You want to fit it loose after you bolt the stubs on. Basically bolt the stubs to the heads tight. Do the rest of the system loose, then tighten everything down.
Other than that, there is not much that can go wrong. The only other thing I can think might be a problem is... The stubs might be matched to a specific port. I vaguely remember my stubs are stamped with dots 1 thru 4. But mine was used so those stamps could have come from the PO. |
|
|
|
Posts in this topic
biosurfer1 New Euro Race headers dont fit? Apr 23 2009, 09:34 PM
JRust Well figure it out damn it! WCR is only weeks ... Apr 23 2009, 10:23 PM charliew You are probably going to need to take it off and ... Apr 23 2009, 10:29 PM biosurfer1 Well mine had stickers on them stating "RR, R... Apr 23 2009, 10:32 PM
jasons
Does anyone know how "Right" "Le... Apr 23 2009, 10:42 PM biosurfer1 Trust me Jamie, non one wants this thing running m... Apr 23 2009, 10:35 PM ConeDodger Brett,
There are two stub pipes that will be tight... Apr 23 2009, 10:39 PM biosurfer1 I checked and unfortunately both sides of the stub... Apr 23 2009, 10:53 PM ChrisNPDrider On mine, the pipes did not line up good at the col... Apr 23 2009, 11:42 PM charliew If one side fitted good without closing or spreadi... Apr 24 2009, 09:16 AM biosurfer1 I can try, but from looking at them, I can't s... Apr 24 2009, 09:42 AM biosurfer1 Thanks guys...I got them on. I just had the passen... Apr 24 2009, 11:30 PM Todd Enlund
Thanks guys...I got them on. I just had the passe... Apr 25 2009, 02:06 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 07:31 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.