 Crossbar linkage is too long, cut and drill or order spacers and wait. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914rat |
 May 16 2009, 10:38 AM
Post
#1
|
|
Member  Group: Members Posts: 279 Joined: 3-July 06 From: Maryland Member No.: 6,362  |
I just installed 40mm dellortos and the crossbar is to long.Do I order the bake a lite spacers ,drill the 4 bolt spacers I have for 3 bolt intake or cut the bar and drill the cut end. .I really dont want to take the carbs off again.
|
   |
 
|
  |
Replies
| VaccaRabite |
May 16 2009, 02:45 PM
Post
#2
|
|
En Garde! Group: Admin Posts: 13,757 Joined: 15-December 03 From: Dallastown, PA Member No.: 1,435 Region Association: MidAtlantic Region 
|
Do you have the spacers between the carbs and the block?
It sounds like you don't. Add the spacers and you will not need to cut the bar. Smear a *little* RVT on the spacer to help it seal to the head and carb base. |
|
|
|
Posts in this topic
914rat Crossbar linkage is too long May 16 2009, 10:38 AM
ConeDodger You must have the spacers Don, they insulate the i... May 16 2009, 12:07 PM
914rat
You must have the spacers Don, they insulate the ... May 16 2009, 12:28 PM tomeric914
... or cut the bar and drill the cut end.
Cut t... May 16 2009, 01:04 PM r_towle Dellortos are better carbs than webers, so dont be... May 16 2009, 08:54 PM URY914 The bars come in several lengths. Put the spacers ... May 16 2009, 09:16 PM ConeDodger Guys - these were my carbs. I sold them to him. Al... May 16 2009, 10:41 PM 914rat I have owned this car since the early 90's and... May 17 2009, 07:17 AM kwales Count yer blessings...
Better too long than too s... May 17 2009, 10:02 AM 914rat I cut off 3/4 in on the bar and have a good 5/8 ad... May 17 2009, 09:13 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 14th July 2025 - 12:17 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.