Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Fuel Pump Hot Wired, Clogged??? Still here the buzz??
thompson-mfr
post May 22 2009, 10:43 AM
Post #1


Thompson, Ryan
**

Group: Members
Posts: 198
Joined: 30-September 08
From: Silverton, OR
Member No.: 9,598
Region Association: Pacific Northwest



I have been trouble shooting my fuel system and hot wired the fuel pump.

I essentially bench tested it in the front trunk with the two output lines going to a gas can and the supply line still hooked up. I just changed the filter and checked to make sure there was flow after the filter and there was.

I applied 12v to the pump correctly with + and - correct (HM!), but no gas through the pump.

Can I blow compressed air gently through the pump to see if there are any obstructions????
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
Cap'n Krusty
post May 22 2009, 11:41 AM
Post #2


Cap'n Krusty
**********

Group: Members
Posts: 10,794
Joined: 24-June 04
From: Santa Maria, CA
Member No.: 2,246
Region Association: Central California



The connection on the pump is clearly marked (+) and (-). Embossed right in the plastic. There is only ONE outlet (D), one inlet (S), and one pressure relief or return ® port. The only way you can properly test the pump is by having a pressure regulator plumbed into the system.

The Cap'n
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 16th June 2024 - 06:44 AM