 Wiring Help, Where do these wires go? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Robert_C |
 May 24 2009, 11:29 PM
Post
#1
|
|
Newbie  Group: Members Posts: 12 Joined: 30-December 08 From: Oklahoma Member No.: 9,885 Region Association: None  |
I've been working on the wiring in my 914, rodents seem to have eaten the front harness in half. I've made a lot of progress, but am unsure of where some wires lead to. The wires in question are a brown wire and a brown wire with a white stripe coming from the fuse panel that splits off and leads to the brake warning light switch. Could someone tell me where these wires lead to?
I think they may lead to the headlight cleaning system relay but I don't have that option. I have looked on a wiring diagram and neither of the wires are listed. Attached are pictures of the front of the car. The wires are on the drivers side near the brake fluid resevoir. Thanks, Robert Attached thumbnail(s)  
|
   |
 
|
  |
Replies
| Dave_Darling |
May 25 2009, 05:50 PM
Post
#2
|
|
914 Idiot Group: Members Posts: 14,991 Joined: 9-January 03 From: Silicon Valley / Kailua-Kona Member No.: 121 Region Association: Northern California 
|
Do a pencil rubbing (remember those??) on the fuel gauge sender. I can see a "G" next to the four-o-clock pin; that would go to the gauge. (Green, was that?) I think one will be marked "WK" and one will have a ground symbol. The WK one will be for the light, the other for the ground wire (brown).
--DD |
|
|
|
Posts in this topic
Robert_C Wiring Help May 24 2009, 11:29 PM
914Sixer Hard to say, they do not appear to be stock. May 25 2009, 07:14 AM type47 Brown is usually a generic ground wire. The only t... May 25 2009, 07:15 AM A&PGirl The 2 red wires against the brake reservoir do not... May 25 2009, 09:08 AM
SirAndy
it looks like the previous owner did a lot of spl... May 25 2009, 11:25 AM Robert_C
We had to replace all the wires going from the f... May 25 2009, 01:07 PM SirAndy
The attached picture from my Haynes manual looks ... May 25 2009, 01:39 PM SirAndy
But as the picture shows, there are four terminal... May 25 2009, 01:42 PM 76-914 I just went thru that entire circuit you are worki... May 25 2009, 04:13 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 12:24 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.