 SS fuel line install questions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bobhasissues |
 Jun 10 2009, 09:30 AM
Post
#1
|
|
seemingly endless issues with my 914  Group: Members Posts: 218 Joined: 13-February 07 From: Chicagoland Member No.: 7,532 Region Association: None  |
Preparing to install the CFR 3/8" SS fuel line in my carbed '73. I will only be installing the single line for the carbs, so what is the best way to terminate the return line nipple coming off the gas tank? Do I tie both nipples together with a "Y" or "T" connector, or is it best to just block off the return nipple? Either way, what hardware works best?
|
   |
 
|
  |
Replies
| neil30076 |
Jun 10 2009, 05:55 PM
Post
#2
|
|
Recovering dismantler! Group: Members Posts: 397 Joined: 12-September 06 From: San Diego ( RB) CA Member No.: 6,826 Region Association: Southwest Region |
Just installed my SS line from Chris. Not difficult, but get the rear of the car high enough before you start. Harder part was getting the pump lines the right length under the tank, capped off the return just like the cap'n said - that was the easiest part.
|
|
|
|
Posts in this topic
bobhasissues SS fuel line install questions Jun 10 2009, 09:30 AM
tat2dphreak
Preparing to install the CFR 3/8" SS fuel li... Jun 10 2009, 09:35 AM
Cap'n Krusty
Preparing to install the CFR 3/8" SS fuel l... Jun 10 2009, 10:33 AM tat2dphreak will do... 3 years since I did that, no leak yet. ... Jun 10 2009, 11:18 AM Cap'n Krusty The salesman at the FLAPS, were his lips moving? ... Jun 10 2009, 11:32 AM topatrout914 I cut the side out of an empty qurt oil container,... Jun 10 2009, 12:57 PM bobhasissues
Preparing to install the CFR 3/8" SS fuel li... Jun 10 2009, 01:06 PM Shade Tree
Preparing to install the CFR 3/8" SS fuel l... Jun 10 2009, 01:12 PM KevinP I think that I would terminate it in an AN-fitting... Jun 10 2009, 01:38 PM jim_hoyland
Just installed my SS line from Chris. Not difficu... Jun 10 2009, 07:55 PM ejm
Just installed my SS line from Chris. Not diffic... Jun 11 2009, 05:27 AM neil30076
Just installed my SS line from Chris. Not diffic... Jun 11 2009, 10:24 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 01:52 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.