 Suggestions on best way to reinstall brake reservoir lines? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ChrisFix |
 Jun 19 2009, 08:41 AM
Post
#1
|
|
Member  Group: Members Posts: 173 Joined: 3-March 05 From: Chapel Hill, NC Member No.: 3,707  |
Hi,
I'm replacing my master cylinder with a new ATE 17mm...in reading up on how to do this, it seems the one difficult step is re-installing the reservoir lines. What are the "best practices" for doing this from you seasoned pros? In looking over the new MC, I noticed if I removed the rubber boot for the reservoir line, there is a small washer under it that easily gets out of place and prevents the boot from re-seating properly...so it would seem that pulling the boot out and putting over the reservoir line and then inserting the line with the boot attached might be problematic... Anyway, I need to get this done today and not spend the entire afternoon fighting with it, so any suggestions from those who have already fought (and won) this battle would be greatly appreciated. Thanks in advance, Chris |
   |
 
|
  |
Replies
| Katmanken |
Jun 20 2009, 12:46 PM
Post
#2
|
|
You haven't seen me if anybody asks... Group: Members Posts: 4,738 Joined: 14-June 03 From: USA Member No.: 819 Region Association: Upper MidWest |
You could be lucky like me....
D*** clear plastic lines decided to leak at the joint with the metal part that fits into the master cylinder. All the fluid ran out overnight..... |
|
|
|
Posts in this topic
ChrisFix Suggestions on best way to reinstall brake reservoir lines? Jun 19 2009, 08:41 AM
So.Cal.914 I use a little brake fluid to get the end of the l... Jun 19 2009, 08:45 AM
ChrisFix
I use a little brake fluid to get the end of the ... Jun 19 2009, 08:59 AM blitZ I did mine after. I took a open end wrench and us... Jun 19 2009, 09:05 AM Vacca Rabite This is one of those jobs that is WAY easier with ... Jun 19 2009, 09:05 AM tat2dphreak when I did it, I had the M/C on, but not tight... ... Jun 19 2009, 09:22 AM rfuerst911sc Get the front of the car in the air on jackstands.... Jun 19 2009, 11:05 AM ChrisFix
Get the front of the car in the air on jackstands... Jun 19 2009, 02:33 PM SUNAB914 Yes, I remember the pain very well. To get the lin... Jun 19 2009, 11:33 AM ArtechnikA if it's not too late to help you (that is, if ... Jun 20 2009, 10:19 AM jaxdream
if it's not too late to help you (that is, if... Jun 20 2009, 10:39 AM ChrisFix
if it's not too late to help you (that is, if... Jun 20 2009, 11:45 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th June 2024 - 11:59 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.