Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Harness all layed in, Except for the dash
PanelBilly
post Jun 20 2009, 08:34 PM
Post #1


914 Guru
*****

Group: Members
Posts: 5,811
Joined: 23-July 06
From: Kent, Wa
Member No.: 6,488
Region Association: Pacific Northwest



Attached Image

Attached Image

I wrapped all the wires in the best electrical tape I could find, just to clean it up a bit more. Several of the wire tabs in the engine compartment are missing, so i need to find some hardware to secure the lines in place. Suggestions are welcome.

The area where the harness comes through the firewall and turns up into the motor mount isn't as clean as I'd like it either, but its where I'm going to stop today.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
McMark
post Jun 20 2009, 08:46 PM
Post #2


914 Freak!
***************

Group: Retired Admin
Posts: 20,179
Joined: 13-March 03
From: Grand Rapids, MI
Member No.: 419
Region Association: None



Looks good. (IMG:style_emoticons/default/thumb3d.gif) (IMG:style_emoticons/default/cool.gif) Except that I loathe electrical tape as a wire wrap since it unwraps in a year or so and leaves an awful, sticky mess.

The dash can seem daunting, but if you work at it little by little it's not too bad.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 1st June 2024 - 03:35 AM