 Rogue Wires, Need a hand identifying where a few wires go |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| saigon71 |
 Jul 3 2009, 03:08 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,025 Joined: 1-June 09 From: Dillsburg, PA Member No.: 10,428 Region Association: MidAtlantic Region 
 |
1974/4 factory fuel injection. I have a white wire that comes out of the harness with the three wire distributor plug. Have searched high & low but can not figure out where it goes (see picture). Also, I have a broken black wire on the non-condenser side of the coil that is connected to another black wire out of the harness. Any ideas? Thanks.
 |
   |
 
|
  |
Replies
| ejm |
Jul 3 2009, 07:37 PM
Post
#2
|
|
I can see the light at the end of the tunnel Group: Members Posts: 2,717 Joined: 3-February 03 From: Massachusetts Member No.: 224 Region Association: None |
Single white wire goes to the thermoswitch for the cold start valve. Pic of the other wire might be helpful.
|
|
|
|
Posts in this topic
saigon71 Rogue Wires Jul 3 2009, 03:08 PM
saigon71
Single white wire goes to the thermoswitch for th... Jul 4 2009, 04:34 AM
qa1142 is you car a 1.8L or 2.0L?
Completely different F... Jul 5 2009, 08:33 AM ejm
is you car a 1.8L or 2.0L?
Completely different ... Jul 5 2009, 09:14 AM saigon71
is you car a 1.8L or 2.0L?
Completely different... Jul 5 2009, 11:15 AM Dave_Darling Tach signal wire. Plugs into the coil (-) termina... Jul 5 2009, 09:39 PM cwpeden Everyone should have one of these on their desktop... Jul 6 2009, 01:40 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 30th April 2026 - 04:33 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.