 ECU borad, need a rebuilder |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Tman914 |
 Jul 9 2009, 07:51 AM
Post
#1
|
|
Member  Group: Members Posts: 136 Joined: 9-December 04 From: "Livermore, Ca" Member No.: 3,247 Region Association: Central California  |
Where can I get a ECU board any one out there
|
   |
 
|
  |
Replies
| SLITS |
Jul 10 2009, 03:18 PM
Post
#2
|
|
"This Utah shit is HARSH!" Group: Benefactors Posts: 13,602 Joined: 22-February 04 From: SoCal Mountains ... Member No.: 1,696 Region Association: None  |
The ground for the fuel pump is the multi-point ground behind the relay panel and is directly wired to the pump.
Are you sure the fuel pump relay is good? Are you sure the power relay (for the brain) is good? Are you sure the fuse on the relay board is good? Pin 13 on the main body harness 14 pin connector is power for the pump. Wire goes thru main harness to fuel pump. Pin one on the 4 pole connector on the relay board is power to the brain from the relay on the relay board. Pin three completes the circuit for the fuel pump relay and is tied to Pin 13 on the 14 pin main body harness connector Pin two is tied into the yellow wire to the starter circuit Pin four appears to be tied into the cold start valve and thermoswitch. Now, if you want to try another brain (044) send me a PM. |
|
|
|
Posts in this topic
Tman914 ECU borad Jul 9 2009, 07:51 AM
SLITS Borad, you will have to see the movie.
Board ....... Jul 9 2009, 07:54 AM Tman914 2.0 D jet 1974 Jul 9 2009, 08:56 AM
SLITS
2.0 D jet 1974
0 280 000 043 or 0 280 000 044
... Jul 9 2009, 10:15 AM Tman914 Theres no number on the case , do i have to take i... Jul 10 2009, 09:51 AM SLITS Nope ..... I doubt the board will have the Bosch p... Jul 10 2009, 11:12 AM Tman914 the fule pump is not comeing on it should get it g... Jul 10 2009, 11:34 AM 76-914 :agree: Ron's right. Check out that power rela... Jul 10 2009, 05:34 PM Tman914 the relays are good I took them from the head ligh... Jul 11 2009, 12:32 AM Tman914 Thanks SLITS
I will get back to you on that just... Jul 11 2009, 10:52 AM tod914 Pelican parts has a tester you can rent. You can ... Jul 11 2009, 12:29 PM 914Owner
Pelican parts has a tester you can rent. You can... Jul 12 2009, 10:02 AM tod914 The relay boards you could try Rich out at High Pe... Jul 12 2009, 12:33 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd May 2026 - 08:27 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.