 rebuild hardware, on my way to Northern Tool |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| machina |
 Feb 23 2004, 11:58 AM
Post
#1
|
|
Advanced Member  Group: Benefactors Posts: 2,030 Joined: 21-June 03 From: Miami Beach, FL Member No.: 848   |
Cleaned out the other side of the garage this weekend to make room for the donor 1974 2.0.
Right now I am planning on getting the following to prepare for removing the motor and starting the tear down. Parts washer Jack with > 17" lift (I have 2 that only go 13") Furniture dolly (to move motor) Anything else I might need there? Also, is the parts washer really necessary? If so, do you use the non-combustable cleaning fluid or is some kind of solvent or fuel the best way to go? Thanks, dr |
   |
 
|
  |
Replies
| cha914 |
Feb 23 2004, 03:53 PM
Post
#2
|
|
MUSR 8 - 5lug conversion done wed - drive 500miles thrus Group: Members Posts: 739 Joined: 31-December 02 From: Austin, TX Member No.: 63 |
Yeah, just blast them in tandem, no special tool...the air helps to blow off the stuff that the brake cleaner loosens up. For really grungy stuff I blast the brake cleaner, let sit, then blast again with the air on it also.
Oh and be sure to be doing this in a well ventilated area with no sparks/flame around...that stuff is toxic and highly combustable (IMG:style_emoticons/default/smash.gif) HTH, Tony |
|
|
|
Posts in this topic
synthesisdv rebuild hardware Feb 23 2004, 11:58 AM
Qarl Shop compressor
Bead blast cabinet
Any old Germa... Feb 23 2004, 01:06 PM tat2dphreak if you're going to bead blast, may as well get... Feb 23 2004, 01:19 PM cha914 Or you could go the cheap route and get a case of ... Feb 23 2004, 01:45 PM synthesisdv 
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 12:39 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.