 Any easy ways to install the 3 piece top targa seal?, One part is half way in, and she fully lubed...and NADA |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| wallys914 |
 Dec 21 2009, 06:43 PM
Post
#1
|
|
In life you don't get what you want, you get what you negoia  Group: Members Posts: 190 Joined: 10-October 08 From: Garden Grove, Member No.: 9,631 Region Association: Southern California  |
I used wd40 to lube up the one side and attempted entry; but failed half way through, the side I was working on just would not budge after I got half stuffed in there....
Any ways to get that seal in with out breaking it? or disfiguring it? |
   |
 
|
  |
Replies
| ahdoman |
Dec 21 2009, 08:57 PM
Post
#2
|
|
It's phonetic...Ah-D-O-Man (Audioman) Group: Members Posts: 667 Joined: 7-November 05 From: Santa Clarita, Ca. Member No.: 5,084 Region Association: Southern California |
Aside from the tracks on the sides make sure all the screws are flush or they'll dig into the rubber and stop it. Also make sure you are pulling it in as well as pushing.
|
|
|
|
Posts in this topic
wallys914 Any easy ways to install the 3 piece top targa seal? Dec 21 2009, 06:43 PM
drgchapman I think WD40 is bad for rubber, not completely sur... Dec 21 2009, 06:56 PM tradisrad I just did my targa seal. I used windex to lube it... Dec 21 2009, 08:39 PM PanelBilly I just talked dirty yo it and slipped it right in.... Dec 21 2009, 09:23 PM Vacca Rabite lots of dish soap. pulled down on the rubber with... Dec 21 2009, 09:52 PM Mikey914 Soapy water.
If it's one of mine PM me you e... Dec 22 2009, 01:27 AM koozy I've done a few and one thing that made it WAY... Dec 22 2009, 02:06 AM *kennyd*914 I think the easiest way to show you would be to ha... Dec 22 2009, 06:13 AM
blitZ I use McGuires rubber restore/protectant. It... Dec 22 2009, 07:24 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 09:13 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.