 Front Hood Badge, Installation Question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| xperu |
 Mar 21 2010, 11:32 AM
Post
#1
|
|
TEXAS  Group: Members Posts: 597 Joined: 13-June 06 From: League City Texas Member No.: 6,213 Region Association: None 
 |
I am replaceing the old badge with a new one, the old has a broken pin and faded, my question is the gasket under the badge is the same contour as the badge, but the gasket seem to small and the badge does not fit inside the gasket ridge. Any suggestions? Mike
|
   |
 
|
  |
Replies
| iamchappy |
Mar 21 2010, 07:45 PM
Post
#2
|
|
It all happens so fast! Group: Members Posts: 4,893 Joined: 5-November 03 From: minnetonka, mn Member No.: 1,315 Region Association: Upper MidWest  |
There are different size badges and gaskets, if you take yours to a dealer parts department they can get you the correct one for your size badge, i had the same problem and ripped a few even after warming them up because they were to small.
The badge will drop right into the correct one. |
|
|
|
Posts in this topic
xperu Front Hood Badge Mar 21 2010, 11:32 AM
Rico Suave They are all like that. Warm the gasket up in hot... Mar 21 2010, 11:44 AM
xperu
They are all like that. Warm the gasket up in ho... Mar 21 2010, 11:53 AM McMark Yup. PITA. Mar 21 2010, 05:02 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 09:36 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.