 914-6 Conversion issues |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| drew5785 |
 Apr 4 2010, 04:10 PM
Post
#1
|
|
Newbie  Group: Members Posts: 5 Joined: 27-January 10 From: brea,ca Member No.: 11,299 Region Association: Southern California  |
I'm almost done on converting my 1.7 4 cyl to the 2.0 6 cyl. Its not a show car, just looking to make a week end warrior. But I'm having trouble with buttoning up the last few lose ends. One is the wiring to the alt. Who ever owned my car before me cut almost everything. So I have the wires coming out of the alt with no where to go, and I'm not sure either ANY IDEAS??
 Also, I stared up the car and the carbs started flooding, after taking them apart I found the foats had sunk. I ordered new ones from Pelican, But did someone make the old ones or are they supposed to look like this?  |
   |
 
|
  |
Replies
| jt914-6 |
Apr 4 2010, 05:55 PM
Post
#2
|
|
Driving & working on teeners 41 years Group: Members Posts: 1,786 Joined: 3-May 08 From: Bryant, Arkansas Member No.: 9,003 Region Association: South East States |
The floats have been crushed for some reason. I would buy a rebuild kit and replace all paper gaskets, rubber O rings, and pump diaphrams. Adjust from scratch like they are new carbs. Use a float guage to adjust floats. Use a vial to adjust pump quantity. (.6-.8 cc per stroke)
On the wires coming from the alt. in the shroud: Large red: connect to hot wire from battery/starter. Brown: connect to D- on regulator/relay board. Small red: connect to D+ on regulator/relay board and to Blue wire to alt. light in guage (idiot light) Blue: connect to DF on regulator/relay board. This wire is green on the relay board diagram....This wire on my six harness from the alt. is black.  |
|
|
|
Posts in this topic
drew5785 914-6 Conversion issues Apr 4 2010, 04:10 PM
Ericv1
I'm almost done on converting my 1.7 4 cyl to... Apr 4 2010, 05:00 PM
drew5785
I'm almost done on converting my 1.7 4 cyl t... Apr 4 2010, 09:12 PM drew5785
The floats have been crushed for some reason. I w... Apr 4 2010, 09:14 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th June 2024 - 03:56 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.