 More trouble adjusting TPS, '72 1.7 |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| BK911 |
 Jun 14 2010, 04:52 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 672 Joined: 19-February 04 From: Rocky Top, TN Member No.: 1,674 Region Association: None  |
I am using this:
http://members.rennlist.com/mikecool/tb1718.gif but am still confused. When I turn completely CCW there is no resistance. As I turn a couple of clicks CW I get continuity. If I keep turning the resistance eventually goes to zero. Am I totaly screwing this up? BTW, I am using a new TPS board from David Sprinkle. Very nicely done. Thanks David!! |
   |
 
|
  |
Replies
| tradisrad |
Jun 14 2010, 05:17 PM
Post
#2
|
|
Senior Member Group: Members Posts: 985 Joined: 11-September 06 From: San Mateo, CA Member No.: 6,815 Region Association: Northern California |
I had the same question and I dont recall getting a good answer. Perhaps the author was using an analog meter and "0" means continuity.
I turn it clock wise until I get continuity and then go one more hash mark. I'm interested to see what ohter have to say... |
|
|
|
Posts in this topic
BK911 More trouble adjusting TPS Jun 14 2010, 04:52 PM
BK911
I had the same question and I dont recall getting... Jun 14 2010, 06:08 PM
r_towle There is an idle circuit that only activates in a ... Jun 14 2010, 06:10 PM Pat Garvey
There is an idle circuit that only activates in a... Jun 14 2010, 06:14 PM tradisrad
There is an idle circuit that only activates in a... Jun 14 2010, 06:34 PM mipstien
There is an idle circuit that only activates in ... Jun 15 2010, 04:36 PM windforfun When I replaced mine, I put the new one in the sam... Jun 16 2010, 03:10 PM detoxcowboy
I am using this:
http://members.rennlist.com/mi... Jun 16 2010, 08:25 PM barndoor Hi Guys
I have been reading this thread,then went ... Oct 29 2012, 01:05 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 23rd May 2024 - 04:11 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.