 -6 Guys, wrench type for right front heat exch nut?, the non-barrel one |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mskala |
 Jun 14 2010, 10:21 AM
Post
#1
|
|
R  Group: Members Posts: 1,935 Joined: 2-January 03 From: Massachusetts Member No.: 79 Region Association: None 
 |
Title says it. For years I've had this long box-end wrench that I've put in
a vise to put several bends in it, still doesn't work well. The heat exchanger itself and the heads are really in the way of the nut on passenger side HE that is closest to the front right. Thanks, Mark S |
   |
 
|
  |
Replies
| ClayPerrine |
Jun 14 2010, 09:33 PM
Post
#2
|
|
Life's been good to me so far..... Group: Admin Posts: 16,422 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille
|
As Betty always reminds me:
"It's not a good job till you cuss at it and bleed on it." And she knows I reserve my profanity for the garage and when I am alone in the car. |
|
|
|
Posts in this topic
mskala -6 Guys, wrench type for right front heat exch nut? Jun 14 2010, 10:21 AM
9146986 IIRC, I use a 1/4" drive with two extensions ... Jun 14 2010, 12:03 PM Cap'n Krusty I use a creatively bent distributor wrench. In fa... Jun 14 2010, 12:18 PM SLITS Bent a 12 mm wrench, then bought a set of Sears 1/... Jun 14 2010, 12:23 PM 6freak Been a long time ..but i thought it was an 11mm an... Jun 14 2010, 12:50 PM mskala At least I'm not the only one. :headbang: Jun 14 2010, 05:29 PM MDG I use, "You F***in' B**ch!" with... Jun 14 2010, 05:39 PM
SLITS
I use, "You F***in' B**ch!" wit... Jun 14 2010, 06:05 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th July 2025 - 09:46 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.