 Tranny Output Flange Play, How much is too much |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rhcb914 |
 Aug 23 2010, 07:26 AM
Post
#1
|
|
member  Group: Members Posts: 360 Joined: 3-February 04 From: Boston, MA Member No.: 1,626  |
I resealed my tranny over the winter and didn't notice too much play in either of the output flanges. I did replace the drivers flange with one from a doner trans because years ago I had the CV bolts back out and it ovaled the hole for the roll pin. I figured since the flanges have to come off to reseal the tranny I may as well change the flange. Now when I checked the CV bolts I noticed I can move that flange up and down, while the other side has minimal play. Is this something to be concerned with or is it just normal?
I plan to unbolt the CV and make sure the bolt didn't back out holding the flange to the dif. Thoughts? |
   |
 
|
  |
Replies
| rhcb914 |
Aug 23 2010, 08:32 AM
Post
#2
|
|
member Group: Members Posts: 360 Joined: 3-February 04 From: Boston, MA Member No.: 1,626 |
Didn't replace the O-ring seal on the dif plate so none of that changed. The only piece that was different was the output flange.
I'll check the tourque on the flanges. If that checks out how can I tell if the flange is bad? Are there some measurements to check? Should I try a few others and take the best fit? Thanks for the replies so far! |
|
|
|
Posts in this topic
rhcb914 Tranny Output Flange Play Aug 23 2010, 07:26 AM
jaxdream One side tight the other not the same ...best remo... Aug 23 2010, 07:32 AM pcar916 There should be no play up and down. Period.
I... Aug 23 2010, 07:46 AM
pcar916
Didn't replace the O-ring seal on the dif pla... Aug 23 2010, 08:50 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd November 2025 - 05:07 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.