 strange new heat issue ok past flapper then no... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| dflesburg |
 Oct 20 2010, 12:18 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,722 Joined: 6-April 04 From: Warm and Cheerful Centerville Ohio Member No.: 1,896 Region Association: None  |
so like it says...
blower motor in engine bay ok down j tube ok in heat exchanger ok thru flapper box ok goes into firewall .... never comes out behind speaker... it did last year. now nothing where is it going? |
   |
 
|
  |
Replies
| windforfun |
Oct 20 2010, 02:16 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 2,058 Joined: 17-December 07 From: Blackhawk, CA Member No.: 8,476 Region Association: None 
|
Ditto. Porsche kinda messed up here IMO. It's one part on the car that's almost impossible to replace. Good luck with the repair.
|
|
|
|
Posts in this topic
dflesburg strange new heat issue ok past flapper then no... Oct 20 2010, 12:18 PM
realred914
so like it says...
blower motor in engine bay ok... Oct 20 2010, 12:25 PM
SirAndy a rat built a nice little nest in there?
:agree: ... Oct 20 2010, 01:21 PM Tom_T Try getting the rat nest out 1st with a coat hange... Oct 20 2010, 01:44 PM dflesburg In all these years I have never heard of one falli... Oct 20 2010, 02:37 PM r_towle get a one inch clear hose and duct tape it to the ... Oct 20 2010, 03:22 PM jaxdream
get a one inch clear hose and duct tape it to the... Oct 20 2010, 04:45 PM windforfun BTW, remember that the tube also acts as a sound m... Oct 20 2010, 05:18 PM GreatPumpkin if thats it, how did they get in, there are no hol... Oct 20 2010, 08:40 PM bandjoey The city water department slides a plastic pipe in... Oct 20 2010, 09:20 PM Eric_Shea
Yes. They need a space about the size of a penn... Oct 20 2010, 09:54 PM windforfun The tube is paper covered aluminum & it's ... Oct 21 2010, 12:18 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st August 2025 - 06:23 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.