 Condensor Wire, Mine seems a little short |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 1988Hawk |
 Oct 28 2010, 06:27 AM
Post
#1
|
|
Newbie  Group: Members Posts: 41 Joined: 17-April 08 From: Chicago Member No.: 8,929 Region Association: None  |
I ordered a condensor from PP for a 75 2.0L with FI. The issue I'm having is that once installed the section from the condensor to the distributor entry "plug" is very taunt, to the point where I am worried about damaging the connectivity. Has anyone esle run into this? Thanks, Jim |
   |
 
|
  |
Replies
| 76-914 |
Oct 28 2010, 08:29 AM
Post
#2
|
|
Repeat Offender & Resident Subaru Antagonist Group: Members Posts: 13,825 Joined: 23-January 09 From: Temecula, CA Member No.: 9,964 Region Association: Southern California 
|
They didn't waste any wire there, did they? It's close. When the points need to be changed switch over to Petronix solid state (<$70) and eliminate that problem.
|
|
|
|
Posts in this topic
1988Hawk Condensor Wire Oct 28 2010, 06:27 AM
dr914@autoatlanta.com no should fit fine I am sure that you mounted the ... Oct 28 2010, 08:28 AM
Drums66
They didn't waste any wire there, did they? I... Oct 28 2010, 11:26 AM Cap'n Krusty Or you could simply continue using the original Bo... Oct 28 2010, 08:49 AM 1988Hawk
Or you could simply continue using the original B... Oct 28 2010, 10:11 AM realred914 Install a Pertronix and never mess with points and... Oct 28 2010, 09:03 AM windforfun My Bosche condenser wire was so long that I had to... Oct 28 2010, 12:10 PM Cap'n Krusty Where's your coil mounted?
The Cap'n Oct 28 2010, 12:51 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th December 2025 - 12:25 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.